Fiber laser cutting machine As a high-tech equipment for metal cutting, it is widely used in metal manufacturing field. Fiber laser cutting machine can cut metal sheets and metal tubes, and it is also ahead of other traditional metal cutting processes in terms of consumables, efficiency and environmental protection. Proper use of fiber laser cutting machine is beneficial to maintain cutting accuracy and extend the service life of the equipment. Therefore, how to safely operate fiber optic metal cutting machine has become a concern for equipment operators.

Safety guidelines when using fiber laser cutting machine
1. before the machine starts working, the operator should check the machine in detail according to the equipment checklist. If a problem is found, immediate action should be taken. If the problem is not solved, do not start the machine without permission.

2. check whether the pneumatic part of the fiber laser cutting machine is leaking, and whether the compressed air pressure meets the requirements. The moisture in the compressed air must be removed before work every day, if there is a leak, please deal with it immediately.

3. check the lubrication hydraulic system and laser cooling system oil level is normal, the water level is normal. If there is a lack of water or oil, it should be replenished in time. The water level of the laser generator cooling water tank should not be lower than the minimum mark. Check whether the water temperature is normal, to ensure that the cooling water temperature meets the standard, so that the machine shines normally.

4. check whether the machine distribution box, power supply, grounding wire, indicators, meters, emergency switches, etc. are normal and reliable.

5. sheet metal laser cutting machine in use to pay attention to moisture, dust, anti-corrosion, and keep the machine clean and well ventilated.

6. check and clean the machine table and the surrounding site, keep it clean and free of waste accumulation. Place the cut metal workpiece in the designated position as required to prevent the machine from being scratched.

7. start the laser cutting equipment for no-load test before work, confirm that the machine is working properly before metal cutting. If the equipment fails, wait for the problem to be solved before turning on the machine to work.

8. because the fiber laser cutting machine needs to be equipped with auxiliary gas when cutting metal. Therefore, it is necessary to check whether the pressure reducer and instrumentation of each gas cylinder is intact, and whether the gas cylinder is firmly installed. The pipe is firmly connected and no gas leakage.

Fiber laser cutting metal tube
In addition to the above checks on the machine, the operator must also pay attention to their own safety.

1. laser machine operators must dry their hands before work. Do not touch the switch or button when your hands are wet, otherwise there is a risk of electric shock. After the machine has completed metal cutting, you need to wear work gloves to pick up the metal workpiece to avoid scratches or burns.

2. When operating the fiber laser cutting machine, the operator needs to wear laser goggles to prevent laser damage to the human eye. Laser goggles are filtered according to the wavelength of laser radiation from the sheet metal cutting machine to protect the human eye.
 
Whether you have a metal laser cutting machine in your workshop, or other CNC equipment, safety in production is very important. Only by mastering the correct steps of using the machine, the fiber laser cutting machine can have a longer service life and ensure the safety of the operator.